Referring to my webpage at:

www.tsc-global.com/rock.htm

I stated that the prongs appear to be worn as they are much rounded
off at their ends. I do not know what material the prongs are made of.
If the prongs are made of a very hard metal, they will wear much less
than the rock around them. I have a steel hand pick that I have used
for decades to cut through hard rock. While my hand pick has busted
and pulverized about a ton of rock over the years, including granite,
it is still in good condition with not a lot of wear. Since the base
material of the manmade-like connector is of rock or some ceramic like
material, it probably is capable of withstanding tremendous heat. The
connector-like component could have been accidentally dropped into the
rock when it was still in a molten state by an alien or member of a
lost advanced civilization many millions of years ago. If the
component is modern manmade, certainly someone should have by now
identified it my its make and model/part #. Can you?

Thanks, John Williams


Doktor DynaSoar <targeting@OMCL.mil> wrote in message news:<q7a430hnkve9jclc0lne051mhhodm3h6h7@4ax.com>...

If the rock is granite, as you say, there's no way the metal pins
could have survived the temperature and pressure. Read up on what it
takes to create an igneous rock.

It was embedded into the rock at some time after the rock's creation. 

On 16 Feb 2004 16:23:22 -0800, wizguru@tsc-global.com (John J.
Williams) wrote:

} Several years ago, I found a granite rock with an embedded modern
} manmade-like connector-like component. My rock is featured in the Feb.
} 2004 issue of UFO Magazine, and also I've been told in an upcoming
} Spring edition of Fortean Times (in Letters section). Don't miss
} either article. This media exposure has provided quite a bit of
} excitement.
} 
} However, without further evaluation, I do not yet know with certainty
} whether my rock is of UFO or lost advanced civilization origin, or
} whether the embedded component is modern manmade and for some
} unexplained fluke or reason ended up embedded in my rock. If my rock
} is indeed a genuine artifact of UFO or advanced civilization origin,
} then it should be able to tell us much about their technology; and my
} rock may also be the hard evidence that skeptics have been screaming
} about for decades that proves the existence of UFOs or lost advanced
} civilizations.
} 
} The webpage below shows clear photos of my rock, plus much descriptive
} material about it. Please visit it:
} 
} www.tsc-global.com/rock.htm
} 
} I am looking for the following contributions:
}     (1) Professional independent evaluations of my rock. There is some
} urgency in doing this because unless and until my rock is determined
} to be a genuine artifact, I will not go through the substantial time
} and expense to take particular actions to obtain and preserve the site
} where I found it, which risks degradation due to human exposure. All
} the help I can get from everyone to speed this process along might
} make a real difference.
}     (2) For those who believe that my rock's component is modern
} manmade, I am interested in anyone who can identify the make and
} part/model number of its embedded component.
}     (3) If you have also witnessed or possessed any rock, petrified
} wood, prehistoric amber, fossil, coal, meteorite, etc with an embedded
} modern manmade-like component, I am very interested in comparing notes
} with you. Years ago, a spark-plug like component was discovered
} embedded in a geode (Olancha, CA, Feb., 1961).
} 
} If you or anyone else you know of can freely provide these
} contributions, please do so. These requested contributions are
} described in detail on the above webpage.
} 
} Thanks. Please respond. John J. Williams, wizguru@tsc-global.com