http://www.members.shaw.ca/dan.mckay/fscoseti.htm
If you have a Windows based computer you will NEED to also download
winima61.exe. There is a trial period if you download it from the
company http://www.winimage.com/download.htm
That will let you take the Linux image and put it on a Linux disk. You
need to format the disk with Linux which Windows by itself cannot do.
The winima program lets you copy an image to the floppy, I went thru
several before it found a good one, it formats as it copies the image.
I use generic floppies, could be part of the problem, could be that
they  were just used too often, or because they have been sitting in
the case for too long?!
You will need a 1.44 meg floppy disk.
The rest of the directions are fairly straight forward.

On Sun, 4 Jan 2004 18:09:04 -0700, "AZ Woody" <Reply@here.not.email>
wrote:

Please post a link...  I'd like to try it!


"f/fgeorge" <f/fgeorge@yourplace.com> wrote in message
news:phbhvvs2a5ftn3o44c79agf44pa140f5a2@4ax.com...

Are you saying that Linux is NOT installed yet?
If not I have a small, floppy based, Linux program, actually it is NOT
mine, I downloaded it and can point you to where, that will run Seti
without a hard drive.
There are a couple of changes you have to make, the directions are
included, so the workunits you complete are credited to you instead of
the writer.
Yes for all of you that have guessed it is the FreeSCOLinux disk.

On Sun, 04 Jan 2004 21:08:32 GMT, "JoeK"
<freedomenduresnospam@yahoo.com> wrote:

Thank You All
I'll try to figure out how to get that thing to run with Linux installed.
It'll be an advanture I'm sure.
Have a nice day.....

"JoeK" <freedomenduresnospam@yahoo.com> wrote in message
news:YqKJb.740795$Fm2.668359@attbi_s04...

Hi all
I am in process of receiving a linux computer. I was told it is

"E-machine"

with 600Mhz P3 processor and 10Gb hard drive. Computer itself is about

3-4

years old. Does it make sense to add such old computer to my small

farm( 3

comp ). I have no knowledge about Linux at all and I would not know how

to

install and run Seti  Driver  . Any suggestions will be very welcome.
Thank you.